Just here for imagination.

[ScarsLove]

That's not far you've been getting ignored

Welcome to the MLK pride! I hope to see you around the forums!

[Ravvij]

That's not far you've been getting ignored

Welcome to the MLK pride! I hope to see you around the forums!

LOL It's alright. I'm used to being ignored. Especially since I have a skill people on this site would start noticing me for. I draw. And pretty much, almost professionally.

[electricocomics]

It seems like I'm always the late comer to all these great forums and nobodies' really on them when I'm into them.

I know the feeling, it was like that for me a few days or so after joining here. Anyways welcome to the Pride Ravvij!

So you draw? another fine artist then! I carve styrofoam myself but do to the properties of my material, I haven't done anything TLK related with that

Oh and sorry for being late on the welcome, my guess is your thread must have been hidden under others...

[Ravvij]

It seems like I'm always the late comer to all these great forums and nobodies' really on them when I'm into them.

I know the feeling, it was like that for me a few days or so after joining here. Anyways welcome to the Pride Ravvij!

So you draw? another fine artist then! I carve styrofoam myself but do to the properties of my material, I haven't done anything TLK related with that

Oh and sorry for being late on the welcome, my guess is your thread must have been hidden under others...

That cool! I've only seen a few things actually being carved from foams. I thought about trying that for a fun project to kill some time and to see if I was any good at it, but I couldn't get my hands on the tools.

Hey, if you want to see my gallery, the link to my DeviantArt should be on my profile. ;D

[The Spirit of Life]

Welcome to MLK

[S1mb4 D4 L10n]

Welcome to the Pride friend

[electricocomics]

If you are using the foam I use, insulation foam for wall, all you will need is a 18mm exacto knife to cut the foam and perhaps a 9 mm to get more detail. I do this way more often so I have a lot of fancier tools but at the core, you only need those two blades. If you do go do it, watch out to not cut yourself! I cannot emphasize enough to be extremely careful when you cut.

Oh and I checked your dA gallery, can I make the Ruger custom! Please, please, please, please, please

[Ravvij]

If you are using the foam I use, insulation foam for wall, all you will need is a 18mm exacto knife to cut the foam and perhaps a 9 mm to get more detail. I do this way more often so I have a lot of fancier tools but at the core, you only need those two blades. If you do go do it, watch out to not cut yourself! I cannot emphasize enough to be extremely careful when you cut.

Oh and I checked your dA gallery, can I make the Ruger custom! Please, please, please, please, please

Sure! As long as you give me credit for the design.

[SimbasGuard]

Hello Ravvij have fun here.